Figure 2 - Top view
Figure 3 - Measurements on the wood to calibrate.
By performing this task, another problems arrived. The points that after this calibration were in the correct place, at least the drawing was equal to the one on the app, were now just a small line instead of a point, this means that the laser is turning on when the galvanometer is still trying to reach the correct coordinate.
After a quick research, it was found that there are a couple of other different variables that needed to be adjusted. Since there is no information on how to calibrate the drivers, this task can't be done, since the drivers need someone with knowledge on this kind of calibrations.
This will be the only topic missing, but, with a calibrated galvanometer, everything that was built and programmed, should work the it.
This way the writing of the thesis will continue.
It is expected an update of the work every week.